Euchner MGB (V2.0.0) Manual do Utilizador

MGB Help for Setup and Service (from V2.0.0)

MGB Help for Setup and Service 3.6 LED DIA illuminated + LED STATE flashes 4 time (AR and AP modes) Fault symptom: The MGB displays the fault state “

MGB Help for Setup and Service 3.8 LED DIA not illuminated + LED STATE not illuminated or does not flash Possible causes:  Teach-in operation compl

MGB Help for Setup and Service 4 System status tables 4.1 MGB-AR Operating mode LED indicator State Error during teach-in / configuration or inva

MGB Help for Setup and Service 4.2 MGB-AP Operating mode LED indicator State Error during teach-in/configuration or invalid DIP switch setting Han

EUCHNER GmbH + Co. KG Telephone +49 711 7597 - 0 Kohlhammerstraße 16 Fax +49 711 753316 D-70771 Leinfelden-Echterdingen www.euchner.de . inf

MGB Help for Setup and Service Page 2/14 Subject to technical modifications 115218-01-03/12

MGB Help for Setup and Service Table of contents 1 Connection...

MGB Help for Setup and Service 1 Connection 1.1 Connection of the buttons in the MGB The terminal assignment of the switches (lights, buttons, emerge

MGB Help for Setup and Service 2 Teach-in operation 2.1 Preparing device for teach-in operation  Connect the MGB as shown below, but do not apply a

MGB Help for Setup and Service 2.2 Teaching in handle module 1. Insert bolt tongue into the evaluation module. 2. Switch on operating voltage UA an

MGB Help for Setup and Service 3 Troubleshooting 3.1 LED DIA illuminated + LED STATE not illuminated (AR and AP modes) Fault symptom: The MGB displa

MGB Help for Setup and Service 3.3 LED DIA illuminated + LED STATE flashes 2 times (single wiring – only AR mode) Fault symptom: The MGB displays t

MGB Help for Setup and Service  All connections are correct, but there is no common potential for the series-connected devices (several power supply