Euchner EKS FSA with USB Interface Manual do Utilizador descarregar pdf (Página 22)

Manual EKS Electronic-Key Adapter USB

Page 22/44 Subject to technical modifications 094485-04-11/13

7 Setup

Perform setup in the following sequence:

1. Set the DIP switches on the Electronic-Key adapter

(see section 4.4 DIP switch settings).

2. Check whether mounting and electrical connection are correct

(see section 5 Installation and section 6 Electrical connection).

3. After connecting the USB connection cable and installation of the EKS USB drivers, the LED on the front of

the Electronic-Key adapter illuminates green. This indicates that the power supply is present.

4. Insert Electronic-Key in the Electronic-Key adapter. The LED changes to yellow.

5. Important: for the version EKS FSA, all safety functions must also be thoroughly tested.

7.1 Installation of the EKS USB drivers under Windows

To start the installation, have the driver software order no. 094376 at hand in a folder or on a data carrier.

 For installation from CD, insert the CD now.

In the routine described in the following, first a driver for the EUCHNER Electronic-Key-System USB is installed

and then a driver for the virtual serial COM port.

Information!

The user must be logged on as an administrator in order to install or uninstall the drivers.

 After the Electronic-Key adapter is plugged into a

spare USB port, the following message appears:

 The Found New Hardware Wizard is started

automatically:

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 43 44

Sem comentários

Euchner EKS FSA with USB Interface Manual do Utilizador Página 22